Differences

This shows you the differences between two versions of the page.

--- hardware:ayn [2026/03/13 23:15] – [Installation] dmanlfc
+++ hardware:ayn [2026/08/20 09:00] (current) – [Table] dmanlfc
@@ Line 1: / Line 1: @@
 ====== AYN ======
-^ Board         ^ Status            ^
+^ Board          ^ Status           | Special Notes         |
-| Odin 1        | Not yet supported |
+| Odin 1         | Supported in 44  |                       |
-| Odin 2        | Supported in 42   |
+| Odin 2         | Supported in 42  | Requires updated ABL  |
-| Odin 2 Portal | Supported in 42   |
+| Odin 2 Portal  | Supported in 42  | Requires updated ABL  |
-| Thor          | Supported in 43   |
+| Odin 3         | Supported in 44  | Requires updated ABL  |
+| Thor           | Supported in 43  | Requires updated ABL  |
 ===== ODIN 1 =====
@@ Line 26: / Line 27: @@
   - Then, if you have your Batocera micro SDCard inserted in your SM8550 device, boot it up and it starts on Batocera.
   - Enter the bootloader fastboot menu by pressing ''[vol -]'' and ''[power]'' and switch the boot mode to Linux (use volume buttons and power to navigate and select).
-  - Then navigate to 'Set device model'. There you can choose your device from the list. Then navigate to 'START' and press power to boot.
+  - Then navigate to 'Set device model'. There you must choose your device from the list (if you don't do it, your machine might not boot). Then navigate to 'START' and press power to boot.
   - If you want to go back to Android, remove the SDCard, enter the boot loader menu by pressing ''[vol +]'' and ''[power]'' and switch the boot selection from Linux to Android. and you'll be back to Android.
@@ Line 33: / Line 34: @@
 {{ :hardware:thor_pre_flash.jpeg?400 |}}
 You can switch from Android to Linux booting from this menu.
+==== Ayn Thor Dual Screen emulators ===
+Emulators with only a single screen (most systems actually) will leverage the bottom screen to run the Batocera Control Center (''hotkey''+''east''), keeping the upper screen for emulation.
+But some systems have dual screen capacity, and here is how to enable them in Batocera 43:
+===Nintendo DS===
+In the ''ADVANCED SYSTEM OPTIONS'' you must select
+  - ''MELONDS'' as the emulator (the standalone one, not libretro-melonds)
+  - set ''DUAL SCREEN'' to ''ON''
+===Nintendo 3DS===
+Only Azahar is supported for the moment. In the ''ADVANCED SYSTEM OPTIONS'' you must select
+  - set ''SCREEN LAYOUT'' to ''SEPARATE WINDOWS''